Adhesive Dispensing Equipment SMT Glue Dispenser
Machine,SMTfly-300M Description:
The 300MM Stepper is our most popular industrial robot with a
dispensing area of 11.81" x 11.81" (300MM X 300MM). The 300MM
Cartesian robot represents a substantial cost saving in comparison
to similar desktop robots. Its overall footprint has a depth of
less than 26 inches (640MM), suitable for an industrial bench. This
line of robots is also available with a low cost vision system.
These bench top industrial robots are ideal for automating a
current dispensing application. With the various work areas offered
almost every application can be fitted on one of the models in this
series; 200, 300 or 400MM Robots.
A program consists of a series of instructions stored in the main
unit, each instruction stored in a numbered memory address. An
address may record a point location, X, Y, and Z axis value, point
type or instruction which sets a certain parameter, such as a
dispensing time or line speed.
Installation:
The automatic dispenser machine can satisfy various requirements
for dispensing, only need to choose different fixtures and math
with dispensing systems.
Adhesive Dispensing Equipment SMT Glue Dispenser
Machine,SMTfly-300MTechnical parameters:
| X/Y/Z Work Area | 300/300/100 MM |
| Work Load | Table/Tool: 10 kg./5 kg |
| Max. Speed | X&Y/Z 800/320 (mm/sec) |
| Repeat ability | +/- 0.02 mm/axis |
| Resolution | 0.001 mm/axis |
| Data Memory | 100 Programs/50,000 points per |
| Drive System | Micro stepping motor |
| Motion Control | Point to point & continuous path |
| Teaching Method | Teach Pendant |
| I/O Signals | 8 inputs/8 outputs |
| External Interface | USB/RS232 |
| Power Supply | 100-240 VAC, 320W |
The following installation instruction is based on the 30CC needle
cylinder clamp and simple type dispensing system as a model.
1. The standard accessories include the 30CC needle cylinder
clamps, and they can be applied to 30CC or 55CC needle cylinder. If
you want to use other needle cylinder, then you have to purchase
other needle cylinder clamps appropriate.
2. Fix the needle cylinder clamps onto the Z axle. Put the hexagon
socket flat head screws through the holes of the clamps and then
lock on the Z ground side. The clamp has a couple of holes to
select, according to the specific requirements .
3. Connect the signal port(three holes) of the dispenser machine on
the backside to the signal port in the controller with dispenser
signal line. The signal port in the dispenser machine is the same
one that connecting with the foot-plate. Thus a problem may appear
that the port can not be shared, if your dispenser machine is not
purchased along with the matching machine. In such case, please
contact us for joint exchanging.
4. Connect the compressed air source to the dispenser controller,
put the needle cylinder collet onto the needle cylinder and tighten
it, and put the needle cylinder into the needle cylinder clamps and
lock the screws which are used to fix the needle cylinder.( Please
don’t over tighten, in case of deformation. And once it deforms,
the piston then cannot fit with the inner side of the needle
cylinder, and cause air leakage.)
5. Connect the hand held programmer to the machine.
6. Connect the dispenser machine and the controller to 220V power
source.
7. Do make sure the pressure pipe of the needle cylinder collect
and the power source will not influence the motion of each axles
and working plate.
Adhesive Dispensing Equipment SMT Glue Dispenser Machine
Application:
